Are you aware of every person who enters your store?
How many times have you had inventory stolen from your store displays?
ENTRY ALERT uses modern PASSIVE INFRARED technology to detect and alert you to every person who enters your store. It is like having an extra pair of ears without hiring additional staff.
Specially designed detection pattern ensures maximum use of shop floor and reception area space. An optical reflector inside the unit, creates an invisible PASSIVE INFRARED sensing 'curtain' of 40 degrees by 5 degrees as per diagram below. As people pass through this 'curtain' they are detected and an alert is made.
Prices from US$106.95.
Standard People Counter
To monitor pedestrian flows, use WATCHMAN PEOPLE COUNTERS.
Anywhere there is the need to track numbers of people passing a certain point, use WATCHMAN PEOPLE COUNTERS.
How many people enter your store or pass your display?
Do you have the right staffing levels to handle the number of customers you service?
Are the aisles in your store adequate to handle pedestrian flow?
Knowing how many people enter your store or pass your display, enables you to maximize space usage.
No more lost sales because you don't have the staff to service customers. Maximize staffing efficiency.
People Counter Remote
The unit is now available with a remote counter module as shown to the right. The remote version is similar to the standard unit, but the number display module is a separate unit.
This counter display module, as shown below, can be mounted in an office away from the sensor unit. The two parts are connected by CAT5 cable and plugs as used for computer network installations.
This remote module has:
1. An external DC input that can be used to supply voltage to power both sensor and display module. (Normally battery operated)
2. A count reset button.
The unit is supplied with sensor unit and remote as shown. Also includes universal mounting kit and installation instructions, but does not included cable.
Prices from US$269.40 for sensor and display. . .
Prices for the SENSOR only for use with computer
systems start at $251.50.
Turbo Timer and Vary Timer
The Turbo Timer is for use in motor vehicles equipped with turbocharger units. All vehicle manufacturers that use turbochargers recommend that after the vehicle has been in use, that the engine is run at idle revolutions for approximately 1 to 1.5 minutes to allow the turbocharger to cool down. This will greatly reduce wear of the turbocharger and so reduce the need for expensive repairs. Priced at US$39.00
Overall size 120mm x 55mm x 30mm.
Turbo Time
These two products will run your engine as required after the ignition is turned off.
The operation is fully automatic, with the timer switching on when the ignition key is
turned off.
The TURBO TIMER has a fixed run time before turning off the engine, and the VARY
TIMER, has by implication of its name, a varying run time. The VARY TIMER run time
is determined by the time the vehicle has been in use. After a short use of say 5
minutes, the run time is approximately 20 seconds, and a long use of 1 hour will
give a run time approximately 1.75 minutes. Further more it has a memory that
remembers when the engine is hot and will continue to give long run times until the
engine cools down. Priced at US45.50.
Each unit is fitted with an emergency cut out push button. Pushing this will terminate
the run time and turn the engine off immediately. Both products come with full
installation instructions and can be fitted by any handyman. There only three wires
to connect to your vehicle wiring.
